1. Disassemble & Wash

1.1Turn Juice Fountain® 'OFF' at the power outlet and unplug.
1.2Remove the Pulp Container by holding the handle and pivoting the bottom of the Pulp Container away from the juicer.
1.3Place both hands on either side of the Locking Arm and pull back and lift over the grooves on either side of the Juicer Cover.
1.4Move the Locking Arm down.
1.5Lift the Juicer Cover off the juicer.
1.6To remove stainless steel Filter Basket, hold base of juicer and turn Filter Bowl surround by the juice spout.
1.7Lift off the Filter Bowl Surround with the stainless steel Filter Basket still in place.
1.8To remove the stainless steel Filter Basket, turn the Filter Bowl Surround upside down and carefully remove the Filter Basket.

We recommend removing the Filter Basket over the sink.
CAUTION: THE STAINLESS STEEL FILTER BASKET CONTAINS SMALL SHARP BLADES TO CUT AND PROCESS FRUITS AND VEGETABLES. DO NOT TOUCH BLADES WHEN HANDLING THE FILTER BASKET.

Wash the Filter Bowl Surround, Filter Basket, Juicer Cover, Food Pusher, Juice Jug, Juice Jug Lid, and Pulp Container in warm soapy water with a soft cloth or nylon brush. Rinse and dry thoroughly.

2. Reassemble

2.1Place the Motor Base on a flat dry surface such as a bench top. Ensure that the Motor Base is switched 'OFF' at the control panel, then unplug the cord.
2.2je95xl_066Place the Filter Bowl Surround on the top of the Motor Base.
2.3Align the arrows on the Juice Disc with the arrows on the Motor Drive Coupling and push down until it clicks into place.

Ensure the Juice Disc is fitted securely inside the Filter Bowl Surround and onto the Motor Base.
2.4Place the Juicer Cover over the Filter Bowl Surround, positioning the Juicer Cover over the stainless steel Filter Disc, and lower into position.
2.5Raise the Safety Locking Arm up and lock into the two grooves on either side of the Juicer Cover.

The Safety Locking Arm should now be in a vertical position and locked into place on top of the Juicer Cover.
2.6Slide the Food Pusher down the feed chute by aligning the groove in the Food Pusher with the small protrusion on the inside of the top of the feed chute.
2.7Place the Pulp Container into position by tilting slightly.

To minimize washing up we suggest that you place a plastic freezer bag (or plastic grocery bag) into the Pulp Container to collect the pulp.
2.8Place the Juice Jug provided under the spout on the right hand side of the juicer. The lid can be placed on to avoid any splatter. A glass could also be used to collect the juice.

The Pulp Container can be emptied during juicing by turning the juicer 'OFF' and then carefully removing the Pulp Container. Replace empty Pulp Container before continuing to juice.

Do not allow the Pulp Container to overfill as this may prevent correct operation or damage the unit.